In addition, a DI-box makes a transformation of an unbalanced guitar signal into a balanced mic-level signal for sending to the input of the DAW (sound card). The main DI-box function is basically the matching of a high guitar pickups’ impedance and a relatively low input impedance of the recording device. When recording “live sounding” guitar cabinet, you can at the same time record a “dry” guitar sound, then, afterwards, using reamping you can achieve the desired result. Even with a live recording of a guitar cabinet with a microphone, you can later find out that you are not quite satisfied with the result, namely, satisfied with the quality of performance, but not satisfied with the quality of the guitar signal processing. In this case you can try to use different amplifiers, audio processing devices and microphone positions. With this technique, you can once record a guitar track and then, an unlimited number of times to playback and record it. The essence of reamping technology is a playback of pre-recorded “dry” guitar signal (the signal from the pickups) through a guitar amp and recording simultaneously with the microphone the guitar cabinet sound. Many sound recording studios use Reamping for getting desired sounding. In the passive mode – you can use the device without a power supply.ĪMT RD-2 lets you record a “dry” sound of your guitar and use it later for reamping – to send the recorded signal to the input of your real loved amplifier. Both functions can be used in Passive or Active modes. It is a DI-box and a ReAmp-box in one device. АМТ Reincarnator RD-2 (DI-box + ReAmp-box)ĪMT Electronics presets a new device – AMT RD-2 “Reincarnator”.